Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys I've had a read through and based on your ideas and thoughts I havemade the decision to double the thickness to 36mm. This should allow a much better battery choice.
I'm hoping this helps?
Im at work. Will get back later.
Many thanks for your efforts guys.
I don't really want to go down the recharging route.
But I did toy with the idea of saving battery by including motion sensor.
I'll read these through properly later.
Many many thanks for your knowledge.
Hi, thanks for the reply.
Yes it has magnets inbedded in the back. It's also slightly curved, like the fridge door.
The night time or timed is just for an easy way to illuminate the led. It's not important how it is achieved.
My electronics knowledge is basic. I work with 3 phase.
Thanks again
No it's simply a fridge magnet for a friend I'm making. The nightime was because I thought a sensor would be easier than a timer.
Thanks for your time.
Hi, I'm hoping someone can help.
Im looking to get 1 led on at nightime only.
But it can only be 15mm deep. Battery as well. Its for a wooden fridge magnet.
Is it possible to do?
First Post. Be gentle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
