Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by wxsimon

  1. W

    limit of on chip resistors matching without trimming

    Without trimming, could <0.25% mismatch of on chip resistors be achieved?
  2. W

    HIgh speed analog layout : considerations?

    Which process is used for this 750MHz LVDS?
  3. W

    ic5 cd3 install and some questions

    ic5 cd3 What is ic5 cd3? I remebered that it had been asked before in the forum, I searched, but nothing found :cry: And how to install it? For linux? Are there some design kits available? Thanks in advance.
  4. W

    Have anyone have LVDS receiver/Transmission circuit ?

    You can search at this site: http://www.esscirc.org/ Good luck!
  5. W

    >100M iopad ESD protection?

    Thanks for reply first. Sorry for my title is not clear. My question is frequency > 100MHz, may parasitic capacitors of ESD protection devices harmful?
  6. W

    >100M iopad ESD protection?

    any idea? wide mosfet or diode? parasitic capacitor of mosfet or resistor harmful? Need suggestion, thx!
  7. W

    Does seven segment led spice model exist?

    NEED LED MODEL Does seven segment led spice model exist? Thanks!
  8. W

    LAN How-to with Red Hat linux 8.0

    Just set ip address of two pc in the same network address. For example, one is 192.168.1.1/255.255.255.0, the other is 192.168.1.2/255.255.255.0 I think you can configure network using system menu, or use netconfig in terminal, or vi /etc/sysconfig/network-scripts/ifcfg-eth0. You can test...
  9. W

    where can i get 0.35um hspice model

    As title. Thanks in advance.

Part and Inventory Search

Back
Top