Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is a print head, the back side of the contact plate.
IC is not connected to the nozzles (except for Vin and GND).
Each of the unrecognized leg IC has a contact on the contact plate.
Since the introduction of memory to the print head, it's always been microwire.
Preceded had memory...
What I know:
- it is EEPROM memory
- dimension (main body): 3 x 3 x 0.5 millimeters
- markings: TO2 HG
What I guess:
- memory size: 256 Bytes
- Vin: 3.3V
What I want to know:
- interface/pinout (I2C, Microwire or something?)
Its predecessor had Microwire EEPROM (Vin, GND, SC, CS, DI, DO)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.