Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: HFSS: ANALASIS ERROR: spiral coil
thank for reply. i change the one layer copper coil and use lumped port. also i change to undercut and connect two port . one port is connected to the ground and the other connected to the copper to avoid short.
but simulation occurs "port refinement...
dear all,
hello, i'm designing the copper spiral coil and find resonance frequency by using HFSS
i located ground and port, and radiation
but analysis doesn't work well and graph is so weird.
could you help me what's problem?
i attached .hfss for reference
-best regard-
Re: HFSS: ANALASIS ERROR: spiral coil
my purpose of the design is to make Magnetic resonance.
and cause of ground directly below the coil is to avoid validate error.
when i seperate coil and ground, validate check always error could you explain more detail???
-BEST REGARD-
Re: HFSS: ANALASIS ERROR: spiral coil
tks for reply.
i revised port wave port to lumped port, but result is same...
Could you explain some detail to create underpass doesn't create a short?
- Sincerely -
Re: HFSS: ANALASIS ERROR: spiral coil
tks for reply.
it is same double layer spiral copper coil and Shielded by an insulator.
i think analysis problem has port problem maybe , could you explain more detail?
is this radiation area fine? it is hard to find problem T.T
HFSS: ANALASIS ERROR: spiral coil
hello i'm design to the spiral antenna for WPT coil to find resonance frequency
i used copper-insulator-copper double layer and validate result OK.
BUT analyze result is so weird and i couldn't find resonance frequency
could you help me? i don't know which part...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.