Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I just finished a new two-channel oscilloscope design, based on a Microchip dsPIC30F2020. It's very simple to build (my record for assembly so far is 39 minutes). Check it out on my scope website:
**broken link removed**
and also the instructable...
schematic oscilloscope
My oscilloscope design is finally finished - hardware as well as software! I put a website together where you can get all the information to build your own:
**broken link removed**
Feedback is always very welcome.
Good luck!
Wolfgang
xilink+xc9572+project
The fastest AVR project I am aware of maxes out at 200 kSamples/sec, I'm not sure anymore of it was on one or two channels (believe it was one). The fastest Microchip (dsPic) based one is around 700 kSamples/sec but only a single channel - which severely limits its...
swordfish osciloscop
That's the plan once I finished circuit development and made the printed circuit board version; everything you need to build your own copy will be available. In the meantime I have completed the one-channel breadboard version, which works great and meets or exceeds all the...
www.soudez.be / joomla / index.php?
Maybe of interest to the people on this thread, I am currently working on a simple, very low cost hobby scope. The design (schematic) and the controller software will be freely available. Preliminary base specs are 1 MSample/sec per channel, analog bandwidth...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
