Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for all the replys. I have tried your 3 coil design betwixt, but have had no results, I have tried switching the ends one at a time and trying different turn of each coil. Then I found a new video and schematic from https://www.electroboom.com/?p=521. I have followed his design except...
Ok so I got a breadboard and some leds and have been doing some testing. So I've got my bottom end of my 1200 turns of small diameter wire going to the base of my transistor. And I have one end of my 7 turn of larger wire going to the positive rail and the other end going to my emitter. On the...
Thanks for the reply. I have tried switching the wire on the base pin and with the one going to power and that didn't help. My transistor is getting warm but it's not like its overheating. Also I tested how many amps it is pulling out of the 12 volt battery back and it was only about .5...
i recently got interested in making a mini tesla coil and things have not been gong so well.I found some online references on how to make them, so i followed them and can not manage to produce any ac voltage. I am getting .5 volts on dc at the top of my coil, which is what my resistor is putting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
