Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I've been reading up on this topologic where they advised my to reconfigure the switches into nmos or pmos. apart from this i will also have to design my own clk and clk bar signal.
As i am still currently learning as a student, i hope you can understand that I do not know how to express my...
i have to use an IC-design software which is Cadence virtuoso to simulate the circuit that i designed. Within the software i can place a DC source.
I'll have to design the circuit from scratch using past references or research that is why i do not have a schematic.
so far i've been reading...
Thank you for your advise. the project specs is asking for hundreds of mW and producing at least 3V voltage output as it is for portable electronics. I also cannot use diodes in my circuit, i have to use mosfets
hello, i would require some advice on the capacitive DC-DC Converter that can generate several selectable DC voltage sources from a single given DC voltage source. The generated DC output voltages are multiple times of the input DC level when unloaded. It uses the concept of the Dickson charge...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.