Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi, thanks for your reply, I understand that by applying Kirchoff Law,
IZ+Vg-Vb=0
I = (Vb-Vg)/(Z)
For the case where both phase shift are zero, I calculated I value from the above equation, Z=0.0628
I= 0.001/0.0628 = 0.016 A
but the simulation result gives 0.03A, what did I miss? Please...
Hi,
Please forgive me for a simple question like this, I am new to this area, and was trying to understand how two voltage sources work when connecting in series.
Please refer to figure 1, I set R=0.0001 ohm, L =0.01 H,
Vb = 10.001V, frequency = 1, phase shift = 0
Vg = 10V, frequency = 1...
I want to use PLL to lock the grid frequency, then I want to synchronize my system frequency to be the same as this grid frequency . Since I know grid frequency is always fixed at 60Hz (for example), I was told that I can instead use a ramp signal along with clock to replace PLL in Simulink, but...
Hi all,
How can a ramp signal and clock be used to replace a PLL (phase locked loop) in the case where I know frequency is always fixed at say 60 Hz?
Thanks
Hi all,
I am working on a simple system working to balance charge among four Li-ion cells in Matlab-Simulink. All the controller and Li-ion cell models are in Matlab-Simulink.
I want to discharge four cells within an hour (3600 seconds), so I work around with the R,V, and I values so that the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
