Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I need to use "Antenna magus" for designing a large array antenna with specific beamwidth. is there any tutorial or help for such a topic?
Thanks in advance
Hi
Anyone have a calculator for planar dipole antenna or any design tool that can calculate the electrical length of the printed dipole?.
Thanks in your interest.
plz, can any one help me to simulate Split Ring Resonator by using HFSS.
I try to resimulate the design in the attached paper, and i use Floquet port for excitation and Master/Slave boundary to repeat the structure, but the result wasn't matched that in the original paper.
i want to know what...
hello,
i have two audio signal with a variable phase shift between them, i use C5515 DSP Kit, i need help to compute the value of this phase shift using code composer studio.
hi,in my attachements ; can anyone help me to find the equivalent dielectric constant for the area under the patch which consist of dielectric material (15 mil) and air cavtiy (35 mil).
i try to use a capacitance model to find the equivalent dielectric constant and it gives the result...
Re: CPW Antenna_HFSS
hi mustafa
here is ur design after excitation
Notes : i notice that u use just 6 pass which cause no convergency for solution
try to use more than 6 pass and also try to use smaller air box for radiation boundary to save ur time
best regards
dear YoungEng
thnks for ur help
i was try to use waveports and also consider the appropriate size of port according to manual but i notice that lumped port is more easier for this problem because as i change dimensions of waveport (according to range in manual) it gives me different reult for...
hfss meshing
i try to design a microstrip patch antenna with a trenches in substrate at 10 GHz
and i assign a special mesh operation (element length 1mm) for the trench only
and let the other objects in the design meshed with default scheme
but i'm not sure that if this is wrong or true...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.