Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
mplap ide
Hi every body,
i am new in the DSP area, i have problem with MPLAB iDE, after i installed it, i was going to start my project. i have selected my device which pic18f97j60, then i tried to do build all from project window. but i got this message as seen in the picture.
so could you...
sim module
Dear friends,
i am going to design system which is using pic 18fxxxx, the system should be able to record voice in MSD card and able to send it using MMS msgs. i need help to find SIMxxx module that has big size file and able to process mms.
second as mentioned i want to connect...
thank you arbj for ur answers, but are you sure the cam will work with the usb, i means there is no any types of image processing needed in the design. bcz i have board the contain the usb and micro controller, 64 pin.
best regards
16f877 web server
thank you so much for reply, one of the things i am worry about the level of micro controller is 16 or 18f or higher in number of bit to combined the cam with the design. if there any relative project or design with data sheet will be very useful for me. thank you so much again.
temperature monitoring 18f4550
Hi every body,
i am going to start new project that is as following:
1. monitoring and access to the security cam from your 3G mobile
2. control the temperature and other devices from the mobile.
can any one help me to start, i al looking first to the...
Hi every body,
i need start my own project in programming PIC 16f628A, i have the programmer kit, and the PIC. i know that the C language will be used to program the PIC.
i need your help to start my first program. how i cant start?
Best regards
Tanner, Tspice
Added after 8 minutes:
realy thank u so much, i have the fft magnitude in db bcs my simulator has the function of fft, but i have to subtract the fft magnitude with what that is my question (what is "the fundamental bin") do u mean the input frequency to the minimum level of...
thank you so much for ur reply, now i have fft file of the ouput, so what is steps after that, how to calculate the SNR?
pls send the m-file i will be very thnkfull.
regards
thank u so much but i need more details, i cant under stand what i have to do exactly:
first i do fft of the output signal than i find the amplitude of the input there(the amplitude should be compare to minimum level or to the noise??
the second step i not understand.
do u have any artcal about...
ur OPAMP has very small load, any way u have to know what is he poles and zeros of ur system for folded cascode with NMOS differential input u can refer to razafi book.
any way the way of getting high phase margin and settling time it can be by increase the current of the cascode, to get haigh...
db maesure
Hi every body,
what is the way of maesuring the SNR of the track/hold circuit. could some one help me.
bcs i dont know how to do it.
best regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
