Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ok, ill draw it out and you can re arrange it to make it fit small, i was half trying to draw it liek i made it then kinda gave up and just finished it. ill draw it now
texas instruments has a footprint for the voltage regulator in these programs:
Cadence Allegro v13.6+
Mentor Boardstation v8.7+
Mentor PADS-PowerPCB v3.5+
i am looking for somone to design me a pcb baord, well not design it, make it into a file that i can send to a board maker. i have already made 3 versions of my board with transfers and etching, i have it as small as i can 1.5 inch x 2 inch. with a professional board it would get smaller and...
thats a good circuit, and would work perfectly but with 2 leds. which i may have to do. id like to use a bi color led which would need one of the supplies be disconnected from the led.
this may be a newbie question but ive searched for 2 hours and cant find anything quite like what im doing. i hope i have the right category. a little on what im doing. i am using a brushless motor (3phase) with a recitfier and a switching voltage regulator to charge a battery pack from a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.