Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi Salu,
step 1: U need to convert the 500v to ADC specification level, for that u need to use a resistor network bepends on step size --fullscale to read.
step 2. then u need to read the samples and then depend upon accuracy of ADC u need to calibrate to giv u accurate value.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.