Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
also, my device has a different impedance when it has a different power source connected to it. (63 Ohms) is it normal for devices to have impedance that changes?
Thanks again everyone. I figured the device input impedance is about 50 ohms because it has 4.9 V and 96mA. However, the device is rated for 3.6V and 100mA. Do you think the voltage will cause any problems? I was going to add a resistor in series to reduce the voltage across the load but any...
Thanks for your help. I have the voltage working now. I tried using another cable and it worked. Now I have a problem with getting enough current. I might be able to figure out the circuit if I knew the output impedance of the usb cable and input impedance of the shaver. i was getting...
I can't get any voltage out my USB cable. I measured the voltage between the red and black wires of a USB cable while it was plugged into my laptop and the multimeter read 0 volts. When I connected these wires with a resistor it was still 0 volts. Does any one know why I'm not getting any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.