Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Resistance of relay coil is 70ohm, and in led I am using 1k resistor as current limiting resistor. I am not adding any external resistance to the relay coil.
I want to drive 5v single channel relay by BC547, I am using 1k resistor at base but relay is not working. I replaced relay with a led and it works fine. So can anyone tell me why led is working but relay is not working.Also I tested voltage by replacing relay at the terminal and it was 5v but...
I have ultrasonic flow meter in which its total reading is reset by mistake. I want to get the total reading upto that mark. So can anyone help to increase its reading manually.
Details of hardware:
This is ultrasonic transducer based in which 2 transducer are given. One is UP and another is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.