Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello there,
I am Vijetha H.N, working in an organization as a PCB Design Engineer. I have a very general query regarding board testing.
When we get the assembled boards, we usually do Impedance testing; we measure the impedance of each voltage test points w.r.t Ground to confirm that the...
Hello there,
I am Vijetha from Bangalore, India.
I am looking for an Octal bidirectional buffer (8 bit buffer) with 2 number of direction pins. 1 direction pin is for 1st 4 bits and another for next 4 bits.
Can you suggest the part for this requirement?
Thanks in advance!
Vijetha
Hai,
For a generic board design i use 12V,2A supply voltage. The board has got many interfaces and the worst case current consumption may be around 1.5A. For this design what can be the bypass capacitor value in the power circuit? Please share the proper way of calculation of bypass capacitor...
Dear Brian,
Thanks for the valuable suggestions.
1.I flooded the hole through solder, it was not working still. I did X-Ray scanning of that particular area, observed that in the n.working board the inner copper wall was not uniform completely. In working board it was uniform. I attached the...
Hi,
We use a Panasonic Lithium coin cell (3V, part #BR2330) for RTC chip DS1307, in the design of a handheld device and its a mass production. Now in some of the boards 2 different issue are found. Please drop your comments/suggestions on the issue.
1. The RTC battery is connected to an 8...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.