Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all,
I finish the PCB layout for the board and now I want to fabricate this layout as 3 boards on one panel via Cadstar.
How Do I go about with it ?
I tried to duplicate the board with its placements but I get this msg "Exceeded product limits for Board outlines."
Please advise. Thanks.
Dear Experts,
I have done the schematic and have completed the pcb placement for the design. I noticed some errors in the component placement(trace connections and component sizes) and I need to update the .scm file and .pcb file.
I have updated the schematic with the changes and once I go...
Re: How to do new parts creation for Cadstar 11 or 12 softwa
Thanks for the Advice :). After doing Menu - Libraries\Parts\Parts Index, I noticed the Parts.lib is not listed in the index. Then I went through Libraries\Parts\files.. to add Parts.lib and it's ok. Thanks again c",)
Dear Experts,
I'm very new to cadstar and I'm having difficulties creating new components( Non - BGA components) for Cadstar software Version 12. Following the self teach guide from cadstar 11 (component/BGA wizard), I tried to create a new schematic symbol and pcb component of a 4x array...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
