Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by vibeeshpv

  1. V

    rf transmitter /receiver module

    these modules r readlily available in de market.connect it to the serial port of the controller enable serial communication,set the baud rate.dont forget to put antenna(some wire)in the module..
  2. V

    Help me with coding 8255 for lighting up numbers using 8x8 LEDs

    Re: 8255 prob how u going to inter face the 8255? r u using microcontroller or some counter?
  3. V

    LCD program :help required

    Also put some delays between the write enale signals..ten chk the pot for the contrast adjustment...
  4. V

    What is the maximum speed support in serial communication(baud rate setting)?

    Re: serial communication for the microcontroller what will be the speed(89c51 series)and PIC
  5. V

    What is the maximum speed support in serial communication(baud rate setting)?

    what is the maximum speed support in serial communication(baud rate setting)?
  6. V

    need guidelines to start writing PIC code in C ?

    Go through the CCP compiler datasheet
  7. V

    Can 8255 be connected with a 8086 microprocessor?

    Re: 8086 Ya u can connect
  8. V

    2 MCUs communicate with each other

    It depends on the application tat means how much data, distance,speed.like tat tell ur specification
  9. V

    C/C++ book about microcontroller programming on AVR Studio

    Re: C/C++ Book on AVR send ur email id ..
  10. V

    Serial communication problems with a R8C microcontroller

    Re: help PLS specify u r microcontroller
  11. V

    Handshake Signals....

    Handshaking is used for the synchronization
  12. V

    controlling speed ac motor with 8051

    Use TRIAC and Optotriac driver also an zerocrossing detector interface it with microcontroller ..fire the triac at diffrent angle.
  13. V

    Need suggestion about triac switching design

    Re: triac switching pls send me some e books of triac tutorials
  14. V

    Need suggestion about triac switching design

    Re: triac switching pls give any suggestions
  15. V

    triac and microcontroller

    triac with microcontroller In this wot is the use of the triac driver if i interface it without driver what would be the output?
See more

Part and Inventory Search

Back
Top