Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yeah you are right i forgot that this is sample image i took some where from internet yeah will add free wheel diode and test it will tell you or show you the results
so i need to send 1.6 A through primary and check across low ohm resistance (across ground and source of mosfet ) it should show reading of 1.6 A say for instance if i have low ohm resistance of 0.2 ohm then on passing 1.6 A switching them at particular frequency then i should measure 0.32 v...
Hi ,
I am designing a Fly-back converter i had calculated most of the components but i am having some doubt. I am having following data
Primary Peak current = 1.6 A
Secondary Current = 9 A
should my primary inductor saturation should be more than 1.6 A to be operated in full load.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
