Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i tried through http//circuits.io/ but there is no graphical lcdpresent in the components.and i also burn normal lcd 16x2 on proteus and its working but graphical lcd is not working. please suggest
hello sir, i checked that rst pin is not connected anywhere and i also gave a delay of 100 ms and then tried but the error is same . actually there is no error in stimulation , it is executing but glcd is unable to display anything and when i see the simulation error message log it displays as...
[T6963C] Data Write [Controller1] attempted during reset. write operation failed
this message is dispayed more than 9000 times during simulation.
my code is:
/*
* openGLCD Library - Hello World
*
* This sketch prints "Hello World!" to the LCD
* and shows the time in seconds since...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.