Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey,
I have this circuit idea of which I'm somewhat confused about its logic on how I should on to implement it.
I have a voltage sensing section that gives me a square wave of 12V DC. This is applied to a buffer stage which produces 2 12V DC Square Waves on parallel lines. One line goes to a...
Ok made few more changes and now getting the right output..
https://obrazki.elektroda.pl/2404526100_1435052033.jpg
One last doubt, this circuit would work only if I have a 230V AC Supply but incase if I have a 230V DC Supply, all the DC would get blocked by the capacitor and so we would not get...
Uploading a more readable figure. I'm supplying 230V ac main supply and converting it to 12V. The power dissipation that i calculated comes out 7.078W and so I have now divided it into 8 resistors of equal resistance of 2.55k.
Could you suggest how to implement the series capacitor to drop the...
I implemented this circuit and am getting the output desired but what I observe is that if I dont connect anything across the Zener diode (i.e. if I remove everything after the capacitor connected parallel to zener diode) i'm getting a constant a 12V but if I connect everything I dont get a 12V...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
