Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply FvM,
But if the problem is with Voltage and current ratings, then at same place i am using same kind of capacitors 3 in parallel among them, everytime only a particular single capacitor is burning. Is there any chance of issue with PCB layout.
Regards,
Vara.
Hello Folks,
I am having a problem with my DC-DC convertor board(24vdc to 12vdc/3A), where my ceramic capacitor is burning out after a long time run in the field. Due to that, fuse is blowing off and i/p protection mosfet also failing. After replacing all with new ones, the board...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
