Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You are a life saver... thanks a lot...that was the problem.. the ground should be connected in one of the corner and it fixed everything, this is a pretty bad flaw with Spectre in my opinion, it gives no warning!
Thanks a million for your help!
Vamsi
I need high Q because I am trying to do transfer power through the link. I agree that rectifier would reduce the Q of the tank. However, the point of the post is not to discuss the circuit topology but to solve the problem with transient simulation in Spectre, Cadence. I have demonstrated a very...
I am trying to design a rectifier block for an inductive link. However, I am facing issues with transient simulation in Spectre, Cadence. As an example following is a simple resonant tank driven by an ac source with 50 ohm input impedance. The ac source is modeled by a sine voltage source with...
Hello,
I am simulating inductive coupling in cadence 6, virtuoso analog design environment. I am trying to study the bevaiour of the circuit with change in the coupling coefficient/mutual inductance between the pair of coils. I am running sp analysis to look at S parameters. I observe that if I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
