Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Transmitting under water
916MHz. I am open to using any thing, the reason I ant to use the transmitters is cause I already use them for a product my comapny makes. so it would be easy. I dont care if the distance is reduces I only need at most 10 feet its for a scuba diving project.
Re: Transmitting under water
I am using the Linx 916 ES transmitters trandmitting at 38400 buad. air distance is about 1000' they are fully potted and sealed.
all I need is about 10' to 15' under water do you think this will happen with no modifications??? at a maximum depth of about 150'
Transmitting under water
I have been working with transmtter modules that have been working quite well I want to try using them for a under water project. is there any thing that I will need to look at or is it proetty much the same as air transmissions?
I was wondering if any one has any good ideas for a part to use for this project.
I need to build a small PCB with a few sensors and a RF transmitter to relay digital info and ID codes.
the over all board size is going to be roughly 0.75" X 3" the signal has to transmitt at least the lenght...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
