Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thankyou Klaus for your quick response.
I have read the datasheet and changed my IC for the third time but the problem is same.
Circuit diagram ��
The motor i am using is 6V DC geared motor
My battery is 6V , 4.5Ah
( Once i was testing my IC L293d and Vcc and GND where...
I have made project " DTMF Based Land Rover ".
The whole circuit is working in usual manner. The voltage at arduino output pins is 3.46 volts.
And pin no 16 and 8 are Vcc of L293d respectively
So they are connected to 6V.
When arduino output is driven into motor drive ic L293d, motors connected...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
