Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Drill Drawing offset
The relative offset of the binary .DRL and Excellon ASCII .TXT drill files in Protel is correctly placed at the origin in the lower left hand corner. These drill files data are with respect to the actual PCB on the drill table. If you use a Gerber viewer like ViewMate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
