Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
So I was learning about on-off control and three position control, and I found some tasks about values of deadband and hysteresis that I simply cannot understand, and see exactly what is going on. I would like if someone can explain which points should I look at. The exact task is what...
Yes, in the meanwhile I changed my Q4 and Q5, since they were small signal BJTs and now the circuit is working properly, but I would like to know how in general load affects this circuit and what can be done to maximize the gain?
Hello everyone.
I am building an audio amplifier using transistors, based on a circuit taken from "Art of Electronics". In the book, the circuit is presented without load resistance, and I understand quite well how the circuit works in general. In my case, I need to have an 8 Ohm resistor at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.