Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The 8V and -8V regulator input voltage is around 15.3V, and -15.3V
Yes it is a lot of extra to dissipate, but they come directly from the transformer and bridge rectifier, so cannot be changed. Based on the schematic, they should be +14V and -13.5V
The +5V and +8V reg. heatsinks are much cooler...
Hello.
I have a GOS 602 scope, (same as the Tenma 72-6800 which already has a thread here on forum) which works fine. I only got it a few days ago.
My concern is, that the -8V regulator (U601) and the 4 vertical power transistors (Q313, Q314, Q315, Q316) get extremely hot. 80+ deg C, or maybe...
Hello!
I would like to share my newest project, a GPS data logger, that I'm planning to use mainly for outdoor activities, hikings.
It was made almost entierly from reused parts, it has a mobile phone display, and also features a graphical compass.
For mor information, schematics, complete...
i2c+radio
I actually tested before, on setting up the chip, and it is working.
I have found the problem for reading the chip. The I2C communication was too fast.
The AM part is still not clear :cry:
For example a divider value of 53502 would give an input frequency of 0Hz...
radio i2c down
Thank You for helping!
I think I understand most of it now, but still have some unclear areas.
As I said earlier, for 3 and 5 divider values (N2) I got nothing troughout the whole tuning range.
Conform to datasheet, the AM ranges from 510KHz to 1710KHz.
Lets presume that I'm...
dlportwriteportuchar scl
Writing the chip works perfectly, I am able to tune the whole FM range without any problems. I attached the schematic for SDA. I've also tried with a 10K pullup resistor, but still nothing.
i2c radio
Hi!
I got from a car radio, a TEA6820T+TEA6811 based stereo tuner.
https://www.alldatasheet.com/datashee.../TEA6820T.html
https://www.alldatasheet.com/datashee...S/TEA6811.html
For testing im using the parallel port in EPP mode. I made some software I2C routins, which I use for...
hi,
I've got a stereo VFD VUmeter based on the AN6870N, which I would like to connect to the line out signal of a sound card, CD player...
From the data sheet, the IC can handle an input voltage between 0 and 8 Volts. I need some ideas to make this work, probably with an opamp with gain and an...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.