Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm a newbie with FPGA and looking for some help in my project.
I have a signal which is a number of pulses of 100 kHz sine sampled at
1 MHz. The problem is that it is shadowed in a number (up to 10) of
interfering continues wave signals at frequencies in 50-200 kHz band,
and I want to suppress...
Hello,
I use MC35i for transmittion over GPRS and for voice calls.
Actions:
1. Connect to GPRS
2. Detecting RING line (incoming call)
3. +++ (switch to AT mode)
4. ATA
5. ATO (switch to DATA mode)
- talk -
6. +++
7. ATH
- long delay, approx. half a minute -
8. disconnetion of voice call and...
Hello all,
I need help on how to interface AD73311 codec with TMS320F28xx through McBSP.
I've read AD73311.pdf but still can not understand what is a reason to send every word two times.
If someone has any experience or source code welcome to chat.
tnx
2djolestojic:
refer to "TMS320x281x DSP Boot ROM Reference Guide" (Literature Number: SPRU095B)
i have another question:
What moment SCITXDA, MDXA, SPISTEA, SPICLK sould be set with response to XRST for proper choice of bootload mode? With no powering down VCC, VCORE and AVCC.
The question...
Newbie in DSP
Hello,
i want to implement audio FSK modem (1200-9600 bps) using DSP processor. what platform do i better to use?
what processor frequency will be enough to do math operations.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.