Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry friends For Responding late as I was busy in Family Medical problems. I will be using two pressure sensors and 4digit SSD LED display or 1602 LCD graphics Dis and Yeah I would Prefer PIC16F series PIC18F also is OK for me
@ Brian
I am sorry my mistake Datasheet says
The MLH has standard output options:
A. 0.5 Vdc to 4.5 Vdc ratiometric output from 5 Vdc excitation
B. 4 mA to 20 mA current from 5 Vdc to 30 Vdc excitation
I am in need to use MLH series High pressure sensor of Honeywell make to interface with PIC16F887. Can anyone suggest basic electronics circuit to be used Here.
Note Sensor gives ratio-metric output from 0 to 200mA
Dear board members,
I am looking for interfacing PIC 16F887 with DS3231+24C32 add-on card readily available over internet. But I am unable to get any Hitec C lib files for the same whereas Arduino libraries are offered by many websites.
Any help will be appreciated
TIA
UnHappy
Yes very correct, as @Audioguru also pointed out. By the way N100 & SL100 both are commonly available NPN transistors having good characteristics for your project. whereas N100 is cheaper compared to SL100
For that much volts you can you any darling-ton transistors like TIP122 one will do with approximately 470E resistance between pin 3 of 555 and base of said transitor
- - - Updated - - -
For that much volts you can you any darling-ton transistors like TIP122 one will do with approximately 470E...
What is the exact load current and how many White LEDs in series/parallel combination?????
that will help in helping you with proper components and schematic to be used
Yes very correct circuit, it is for cool and safe operation of MosFet With Filament lamps being inductive load, as you know MosFet are very sensitive devices which tend to burn/blow off, if not switched On/Off properly.
Secondly all your listed MosFet are N channel any one can be used. In my...
Very correct, while using MosFet you need to wire two transistor (one NPN & one PNP) in a "totem pole" configuration which means that can source or sink
current
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
