Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Experts,
I need to simulate Center Tap Transformer for step up operation (12V to 230V) to run two MOSFET in primary side to make an inverter circuit.
How to configure transformer in PROTEUS.
Thanks n Regards.
Hi All,
I am using Altium Designer 17.1. But Component library is having very very limited components.
Can any one guide me from where to down load component library.
Or pls. send me files for basic components .
Thanks a Lot.
Hi,
If you have datasheet/ part no/manufacturer of shown component, you can create part in Eagle library.
What is the PCB size?? Hope this is 2Layer PCB. I am freelancer, using Eagle, If you wish i can provide you Gerber file.
Hi,
I am not expert in design. I just surf net and tried to simulate this circuit on protius.
Pls. see attachment.
Will try other circuit as you advised.
Need help in making 1VAC to 1VDC converter. I tried to simulate on PROTEUS different OP-AMP circuits available on net. But not working. it always give high voltage(supply voltage) at output when input is given 1VAC.
May pls. help.
Hi,
Thanks a lot for your valuable comments.
So if i increase the Total voltage(at present 100VDC), Vf will increase (till i get Max Fwd voltage) across each diode so the Current according to vF vs If graph.
Hi,
I have Diode Bank of 100nos of Diode (SF4007) are are connected in series. My aim is to test this diode bank on full load. SF4007 has iMax =1A, Peak reverse voltage is 1000V.
This Diode bank is connected to 30Ohm 300W resistance which is again in series. I am giving 100VDC to
Anode of bank...
Dear experts,
Please help me to findout simulation error. I am getting error msg as shown in attached pics.
Circuit shown is to just check whether UC3842 is working in Proteus 8.0 version or not.
Simulation does not stop but gives error. I doubt on Model UC3842 files (.MDF, .IDX, .LIB) which i...
Dear Mr Tahmid,
I am new in your group. I am designing TL494 based SMPS. could you pls help me in providing TL494 proteus library (7.8 ver) for simulation.
Thanks in advance.
Uj1964
Looking for SG3524 or any similar PWM IC library for PROTEUS 7.8 ver. for SMPS simulation.
It is not in Proteus 7.8 ver Library. I got .mdf/.Sec/.Dsn file for UC2524.But these file extension is not
supported by Proteus7.8Ver. Can any one has PWM ICs library for Proteus 7.8 Ver
8-)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.