Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I am sending Assign NAD request as 08 06 B0 11 00 00 00 02 where C1, C2 and C3 are grounded
I am not getting any response from the slave
I tried sending messages through LIN analyser also but the error I get is timeout
Any ideas why this could happen
Hi
I am doing a project to make a switch for automotibles using LIN communication. I am using NXP UJA1069 AND UJA20123 LIN Master and Slave.
Can anyone help me with some examples of LIN or how to implement LIN on codewarrior.
I am trying to interface nrf24l01 with Arduino.
How to send command bytes to nrf24l01 for reading the status registers?
How to read the status register of nrf24l01?
Thanking You
We have made a rectangular patch antenna at 2.5Ghz.
How to get the gain values at different points in the radiation pattern of the patch antenna in HFSS?
Thanking You
We are designing for 2.4Ghz frequency wit a desired range of around 50 m. The radio chip maximum output is 0 db.
Which type of printed circuit antenna is most suitable for this?
What is the major difference between an inverted F and Patch antenna?
Thanking you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
