Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I went through your code and the drawings. Firstly, I assume the PCB corresponds with the schematic, I'm not going to check that.
The code:
It seems that the micro performs a scan of FM band and lists availabel frequencies while it should end at 108.0 MHz. My question is: Is there any...
Ad 1:
IF counter (and mainly its reading) is very useful when performing autotuning, both built in TEA5767 and semi-automatic from the micro. I am currently using the micro because it is the only way you can see actual frequency currently being checked. Complete and detailed information...
Hi,
I must say that I almost gave up all hope. As far as I went through the datasheet (for the IC, not the module) and appnote as well, I found something about shortened write. That's a tricky thing, because if I want the IF counter to refresh signal level, I have to do a full write and a read...
Hello,
I recently bought radio receiver module with IC TEA5767. It works fine, cooperates well with TDA7330 RDS decoder, but there is one tricky issue with this circuit. Every write/read operation is audible in the reception and it demonstrates as a strong *****. The software includes timed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.