Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need the schematic of a programmer cable for this PLC.
I have the FPC101 and MAC100 configuration, and i have a bus connector to. On this connector is the following: RS232C. And this is a 25 pin female connector.
I have make a RS232 null modem cable but that was no good.
I can not connecting...
I want to make a remote controller for a robot.
I need no chips, i need modules, with an input, an antenna output and a power supply input.
But many thanks for the help.
I have configured LVP_OFF.
But when LVP is on then i mean RB7, RB6 will not work to. This pins are good. Only with the RB3 and RB4 is problem.
But the RC port is with I2C multiplexed (RC3 and RC4). The I2C mode but i have turned off.
I dont know what is the problem.
Sorry to my english
Tomo
PIC problem
I programming a PIC16LF877 device. I have wrote an easy subrutin:
PROG
BSF XSET
BSF YSET
BSF ZSET
BSF AUTOLED
L6
BSF ACK ;PROGRAM INDULHAT
CALL WAITMS
BCF ACK
MOVF PORTB,0
MOVWF PORTC ;MÁSOLÁS PORTC -RE, AHOL A MOTOROK VANNAK
CALL WAITMS
BTFSS ALAPH ;HA NEM...
With witch IC can i replace the UM66T19S?
The UM66T19L loop until the power is on.
OR
If anybody have a litle doorbell schematic post me please!
Thanx!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
