Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
haha good to have a reply Neyolight!
I actually already figured out the pin configurations. Now I am having trouble getting a real reading from my Honeywell I2C Pressure sensor. With this sensor, the ACK is sent from the sensor and then the data is transmitted. I am having trouble seeing the...
Hi all,
I am designing a pressure sensor network and I am needed to figure out how to retrieve the data from the sensor. The data is in two separate bytes with the first two bits being status bits. Do you know how i can save just the information in the particular bits? I will attach the...
Hi All,
I am designing an I2C Sensor network using the PicDem 2 Plus and i am attempting to attach my own external Sensors to show the ability to have multiple sensors on the same SCL and SDA lines. The PicDem 2 Plus Users manual describes the J20-J22 Jumpers below:
TABLE 1-1: ON-BOARD JUMPER...
Re: Understanding Fosc (PIC18F4620) J20-J23 Jumpers
Hi All,
I am designing an I2C Sensor network using the PicDem 2 Plus and i am attempting to attach my own external Sensors to show the ability to have multiple sensors on the same SCL and SDA lines. The PicDem 2 Plus Users manual describes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
