Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using the flip 3.4.1 version, and the programming is working fine for me. I use the following command "C:\Program Files\Atmel\Flip 3.4.1\bin\batchisp.exe -device ATOCDTARGET -hardware RS232 -port COM3 -baudrate 19200 -ocd C51 -operation MEMORY 14 LOADBUFFER %H PROGRAM".
Regards,
Koteswara
Re: atmel at89sxx isp flash programmer
Hi,
I tried using the ISP programmer mentioned in the above link with correct serial port number, I am getting the unable to connect to the serial port error message. When tried using the hyperterminal for sending the commands I am able to get the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.