Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello!
I'm not really interested into chemistry emulation. I'd like to simulate battery functionality to make test of different phases of battery charging and state when battery is fully charged.
Best regards!
Danilo
Hello!
I have on specific question.
Does anyone have any idea how to replace NiMh battery with some kind simulation circuit.
I would need that for testing charging circuits.
Any idea is wellcome.
Regards!
Hello!
I'd like to make housing for prismatic Li-Ion battery pack to be water proof(IP67).
I'd like to now how should be housing built to be safe since we now the possible safety threats of Li-Ion battery pack.
Regards!
Hello!
I'd like to get more infomations on DMS systems in companies size of 50 developers.
What are your proposals for CAD, EDA, Office documents.... or any other.
Best regards!
Hello!
I'd like to now how should I process signal from radar transciever output I/Q that I'll get best result in speed meassurement of vehicle speed.
Any info is velcome.
Best regards!
Re: Protel footprint
Hello!
I have done so:
1 Place normal pad
2 I have defined Paste Mask Expansion and Solder Mask Expansion to be totaly covered
3 After that I have placed separatly solder mask and paste mask opening
It looks ok. Not so easy yob for first time.
Regards!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
