Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to measure the current flow into my boost converter circuit. I use Keysight power supply model E3648A, it has sense terminal (s+ and s-). Can I use the sense terminal to measure voltage drop over the sense resistor?
Thx
Does the ADE L simulation run with multi-core? When the simulation running I just saw 1 core usage 100% and the others around 10% usage. How can I run the simulation with multi-core so that can reduce simulation time?
Thanks!
I designed a CMOS buffer to drive fets (size w=100u, l=2u). This design worked well with frequency below 1MHz. But now i need to raise the frequency to 50MHz and this buffer cannot adapt this frequency (the pulse has overlap). Pls help me!! Thank you all
In my lab, I've fabricated PMIC test board. And I have trouble with measuring the power because of the voltage drop cause by the ammeter. Does anyone have experience in testing low power PMIC? please help me. thank you so much
I need to generate negative voltage from positive voltage about 600mV. And need to minimize power consumption.
Please give me some suggestions to choose!!! Tks u so much!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.