Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
can anyone recommend any analog electronics books in which they main focus of the writer is on the reason why a particular component is used at a certain position of a circuit????
thanx
about your doubt, yeah i am well aware of that common mistake and i am not making that mistake.
the hex files of the sample codes that came with the board are in assembly and they are working fine.
and yes i have checked all the hardware connection for more than a dozen time and i am reasonably...
the onchip crystal is of 10MHz with label M10 000Z. No there arent any pull up resistor with any pin.
---------- Post added at 17:53 ---------- Previous post was at 17:43 ----------
Here is a snapshot of the board
[/url][/IMG]
i have deleted the hex file and rebuilt the project, another hex file is generated but upon burning port A is behaving the same way i.e., it is continuously giving high on the whole port.
yes the program is working in mplab simulator as well as in proteus.
---------- Post added at 13:36...
i am trying to burn hex file of a c program in pic18f458 using mplab 8.56 and development board CP-PIC V3. my code gets build without any error or warning and it also gets burned in the controller but the code is not producing any results( even simple programs like toggling a port is not working...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
