Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you very very much I have attached a few pictures (some redundant) but hopefully gives you what you need to see. Thank you you have been very helpful.
I agree 100 percent, parts seem fairly cheap and I would rather replace a part that doesn't need to be replaced necessarily then spend 1000 dollars replacing 3 fans. Like I said I tried every place local around a 50 mile radius I could and no one local would even look at it. The only test...
Here is a picture of both boards. The board on the right in the lower left corner is where the 78l05 is. The left board in the lower right is where the diode was if this is a better picture and helps you figure it out. I took a picture or that copper wound coil if thst helps out. Thank you...
I asked the fan manufacture for a wiring schematic and they said they didn't have one. Here is the circuit board both sides, the part was in the empty slot labeled 17 where the board is extra brown (burnt brown). I appreciate it.
Yes the first 2 pictures are of one component, the second 2 pictures are of another (2nd) component, that as I said are pretty sure are the culprit of failure.
The numbers on the first component (in the first 2 pictues) are
78L05
A414
THE best I can tell.
THE numbers on the second 2 pictures...
I have a large family room with 3 identical fans. One of the fans quit working. It has no pull strings only a remote. I really don't want to replace just one fan and keep the other 2 nor do I want to replace all 3. I have tried a few online sources and the manufacture and parts are no longer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
