Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have designed a temp controller. The temp from the sensor is measured and amplified. I have an relay in my circuit.
The relay is connected with the Analog port, but in different pin.
Whenever the relay gets turned on the ADC value gets increased.
The voltage reference is same at all...
I have designed a push pull inverter. Driving 48V dc to Ac. I have used the push pull configuration. When the MOSFETs are switching alternatively the mosfet getting heated.
Then i noticed that the gate is ringing. How can i solve this? Why my mosfet it being heated?
Please let me know how to calculate the primary turns,.
As your advise, Ill select ETD44, And ill set Bmax as 150mT, Frequency 20000Hz, Max Duty Cycle - 40 Percent
Npri = ?
I need to design a high voltage transformer, 12V to input (Push pull Topology), Center tapped transformer, 2KV output.
Im having ETD29 ferrite core with me with BMAX = 490mT, Ac = 0.76 square centimetre, Duty Cycle of Maximum 40% (Because of Push pull Topology)
I need to know the number of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
