Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In my view an ADC requires an analog signal which is AC but a micro controller requires a DC , if u want both AC and DC first just use a step down transformer of your requirement.Then use a rectifier circuit so that it converts it into DC ,Now before giving to the rectifier just take same...
Hi Friends,
I am teja i did a project on call as micro controller base automation for auditorium.
I used 2 IR recievers and trasmitters these are connected to port 3.0,3.1 of 89c52.The outputs are taken from pot 1.0 as i placed a uln2003 as driver for devices.So, my prblem is that i wrote a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
