Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you. But...
I found out my user's manual has a link to the proper IDE, also linux compatible. I feel slow. :-( It has some issue with the serial ports option greyed out, but that's whole another isse.
Just a quick question: in the official documentation of that board ( Tiva C Series TM4C123G LaunchPad Evaluation Board ) it requires IDE which runs only under Windows. Am I locked to that OS, or can the chip be programmed with another IDE, which runs under Linux? I assume most processors can be...
So I have to make a USB to RS232 converter using ft232r on a custom designed board. Soldered everything, connected to the PC, installed the drivers and then ran the provided test program. It gave the following error:
Failed to initialize onboard COM tester
as a reason for this error is...
So the paste mask should be smaller that the solder mask? In the image here
is the silverish thing solder mask and the spot-patterned thing on top of it - paste mask? Did I get it right?
What's the difference between solder mask and paste mask layers in gerber files? I don't quite get it and there is no obvious place to read about it either.
p.s. I'm not quite sure where this topic belongs, so I put it here
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
