Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
attiny26 nimh charger
RenatoBR,
So far I can see the charger is working. It discharge, waits 35 seconds and then starts charging. I didn't wait for the whole chargeprocess to complete. Is your charger showing a charging status via the serial port?
I'm not able to test the charger for a couple...
best sla battery charger circuit
Dexter,
After the discharge, the status on the serial monitor changes from Dch to Bin.
I assume Bin means batteries in and 35 seconds cooling down. After 35 seconds the charge starts but te status remains on Bin. Is this normal?
smart battery 3-pin current sensor 52 ohm
I cannot find the configuration bits in my programmer software (bumblebee and galvawisp). I therefore opened the hex in ic-prog, set the configuration bits and saved it. Let's hope this works.
battery carger schematics
I didn't forgot the resistors on portB to the display.
The latest version you've posted, was it a "snapshot" or a compiled hex-file?
Only the snapshot is working for some reason.
solar battery charger nimh kmitl.ac.th
Hi Dexter Dude,
This chager is exactly what I was looking for! Great work, thanks. I needed a charger with a serial output. I've build the charger and for some reason Í'm only able to burn the PIC (with bumblebee) with the "snapshot" file you created. Is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.