Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by taylane

  1. T

    Simple power supply for rf module

    IanP is right. A good linear regulator will do the job assuming cw low power operation. If the PA stage of the transmitter is likely to transmit high power (and possibly saturated) spikes, the capacitor requirement at the output of the linear regulator may require extra attention. In this case...
  2. T

    Data from Agilent Network analyzer

    "classical radar motion detection " ==> classical motion techniques rely on the doppler information inherent on the carrier wave. Now, to fetch the doppler information you need to make abservation, or in other words check the time derivative of phase at a specific frequency. So you need a series...
  3. T

    FR4 and stripline very lossy

    I think excitation of stripline from coax can cause problems. If the groundconnection from coax to both groundlayers of stripline is not enough, you may have created extra parallel plate em modes in the structure causing losses and poor directivity
  4. T

    Schottky diode selection

    There was a book by Steve Maas, I cannot remember the full name, but it was something like: "Microwave Cookbook". This book includes extensive information about the utilization of diodes in various areas of Microwave Design. You can find detailed info on diode selection for your application.
  5. T

    why we have to take .dxf file for our simulation

    It's just for fabrication. The manufacturer is not interested in your design but the pattern at each specific layer of your design. In the manufacturing phase the following items are required: * A dxf file containing the conductor pattern at each layer of your design. In the dxf file you can...
  6. T

    Statistical error analysis on phased array antennas

    Eli Brookner'ın istatistiki hatalar ile ilgili makaleleri var, ama Monte Carlo metodu değil de analitik yöntemler ile hesaplamalar yapmış. Ayrıca "Phased Array Antennas" - (R.C. Hansen) adında bir kitap vardı, O kitapda da konu ile ilgili bilgiler var, en azından kitabın referansları yararlı...

Part and Inventory Search

Back
Top