Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm kind of new to this, the only thing related to interrupts I did before was 3 blinking leds at different rates, and it worked with the aux1 and aux2 counting overflows . I've already tried inicializing the timer and activate the interrupt after I turn on the leds, but it didn't work either...
Hello everyone,
I'm doing a project that is almost finished, I just have one small problem. Days have gone by and I can't seem to solve it. I'm using uvision from keil to program and an AT89S51 (11,0592MHz crystal).
I have 2 leds, one green (P2_2), and one red (P2_3). I'm using a UART...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
