Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hii,
start by typing
1- at+cmgf=1 and press ente...... for setting preference as text sms.
2- at+cmgs= "10 digit mobile number" and press enter
cursor will come >"type ur message here and press ctrl+z
after that ur sms will transmit
notice: these r the commands for SIM 300 GSM...
for input voltage u shoul be taking
1> adapter of 12v
2> 9 -o-9 ct transformer with power supply ckt of 7812 ic(78 means + and 12 means 12 volt) (+12 v)
https://www.pcsilencioso.com/cpemma/317calc.html
if u r using <1> ,<2> then u simply connect your LM337 to the adpater output>>>> for...
hello,
USE VARIABLE VOLTAGE REGUALTOR LIKE LM317 OR LM 337..FOLLOW THIS LINK AND GET A CALCULATOR TO GET UR DESIRED VOLTAGE...
https://diyaudioprojects.com/Technical/Voltage-Regulator/
Re: Why a tester shows glow in rectified DC output
hello the output obtained is 12v (1 AMP current) due to this the tester glows...when after getting o/p from bridge rectifier the output should be fed into ics 7805 and 7812
so that a suitable and perfect filtered output of 12v and 5 volt is...
hii,,,
1-u acn use 5v supply but to connect with micro controller u should use a resister which will drop 5v to 3.3..
2-it will also do good if u supply 5v from a adapter and then drop the voltage by using suitable resisters.it works
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.