Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I need some help for my design. I have placed capacitors at the end of my monopole antenna but when i change my dielectric of my coaxial cable to air due to my return loss is very poor, my capacitors cannot be used. Could someone help me please?
I have attached my design.
Thank you
Urgent Help needed.
I have designed a monopole antenna with capacitor. I have placed my capacitor vertically upwards with current flowing down to ground. I have tried to run the simulations in 2 different computers and i get 2 different results for frequency.
Even with the same computer, i...
I have tried to place my capacitor as a plane in HFSS and put it vertically upright. With the current flowing to ground. But i tried simulating this in 3 different system and i get 3 different results. Can tell me why do i have such problem?
Hi,
I am designing a monopole antenna. The image below is my design. I have drawn 2 wires connecting down from my monopole and also 2 plane for the capacitor. I would like to know how am i going to connect the wires to the capacitor?
Please help me as i need help urgently. I need to finish...
Re: Tunable HF antenna
Please help me.. I am rushing for my project and i am stuck. I have found a paper on sleeve antenna with ground wires.
Can someone explain to me what is a λ/4 sperrtopf?
another thing is using HFSS, can i just extend the center of the coaxial cable and treat it as my...
Re: Tunable HF antenna
I am using HFSS for simulation. It is a software given to me to use it.
I was thinking of using lumped elements that can be screwed to the "ground". On the other hand, I do have an idea of placing a board above the ground so that i can place the lumped elements.
Re: Tunable HF antenna
My initial design was just a coax but running the simulation without the lumped components, my results was not that good. Thus i changed my design to be this way. I can try to re-design my antenna but i do not know what kind of lumped materials i can use.
Is there any...
Re: Tunable HF antenna
nope. I understand that discone is a cone at the top but mine is just like the sleeve antenna but i am asked to connect wires down from the top to the dielectric lump elements for tuning purpose.
Re: Tunable HF antenna
The monopole antenna will be at the top. But at the top it is not a cone therefore i did not think that it is a discone.
Please help me as i am stuck for my project. Thanks.
Re: Tunable HF antenna
Sorry.. I am new at this i would appreciate if you could explain a little to me. I have attached my idea of the monopole antenna.
If i am not wrong it is the monopole element that i would like to be tuned.
dielectric hf antenna
Hi,
Currently i am designing a simple monopole antenna. My design is something similar to a sleeve antenna. I would like to seek help in knowing what are the dielectric materials that i can use for tuning the monopole antenna.
Thanks for your help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.