Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
what is wifi?
Wifi has a range of 100 meter so you can't use it with few kilometers. Other one is Wimax which actually can be used within about 30 kilometer range.
Secondly, You can transfer you data without the presence of Internet but the range matters a lot.
Which operating system are you using.
If you are using Windows Vista or Windows 7.
Then By Default the telent command is not available. You can enable telnet command from "Turn On/Off windows features" from "Add remove program"
VOIP OVER WAN NETWORK
Here you will find how you can configure cisco router for voip
http://www.cisco.com/en/US/docs/routers/access/1700/1751/software/configuration/guide/Config.html
You don't need to buy cisco switch or router only for passing exams. You can practice your commands on simulators like
GNS3
Packet Tracer
Boson Netsim
Study CCNA study material and thats all.
I am telling you that because GNS3 use original IOS of Cisco Routers, so there is no need to buy. You...
If you want to connect two routers with each other then you will have to use cross-over and if you want to use switch in between them then you should use straight through.
CCNA VS MCSE
MSCE is Microsoft Certified System Engineer and it is based on LAN and basically a computer based networking. Where as the CCNA (Cisco Certified Network Associate) is a knowledge of Switches and Routers and based on WAN.
Matter of Fact is both are different.
Therefore by comment...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.