Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Sorry for posting here guys, I guess most of ppl reading this forum (including me). I am insterested for a programmer/schematics to upload and download data to/from a samsung K9F6408U0C TCB0 flash memory (its a NAND flash memory 2.7V 8Mx8bits).
Anybody has any idea what programmer I can use...
H8/325
Hi,
Anyone knows where can I find a development kit for Hitachi H8/328. Will that be same for all H8 MCUs? Is this same as the Renesas H8 MCUs?
Sorry for asking but I dont know nothing about these so any info it will particularly useful for me.
Regards,
icd2 firmware icd01020605.hex
@Crazyduck
Hi,
Thank you for clearing up this issue with the C12 capacitor.
However there is also the issue with the C10 one. If you looked the datasheets of MAX232 you must have seen that the plus pin of C10 should be connected to pin2 of MAX232 *but* the other...
cypress eeprom
HI,
I was wondering if anyone has a copy of an ICD2 USB eeprom. Usually in ICD2 there is a cypress EZ-USB MCU and an external eeprom attached to it. I am looking for the contents of that eeprom in hex format and/or if possible, in more detailed form (PID, VID etc).
B.R.
ccs for pic 877a rs232c
Hi,
@Crazyduck
Can you please clear up (regarding your schematics), what is the correct polarity for the capacitor C12 (pins 4,5 of MAX232) and also the capacitor C10 (pin 2 of MAX232 to GND?). Kindly please explain us what is correct as you have uploaded several...
silab programmer
HI,
Depends which family. If your family has JTAG then you can use flashblaster (above post). If it only has C2 nterface then use silabs original ide software and EC2. For EC2 look in this forum for schematics.
B.R.
xilinx parallel cable 4 amber led
Hi,
Not true really, PIII cable works fine with impact programmer v6.2i. Just take extra care on the "unusual value" resistor 5K1. It is very *crucial*. If you dont have one with that value just put 4K7+390R+10R (all 1%) together. The problems with all...
impact download xilinx
Hi,
I have some Xilinx XCR3064s that I want to program. I have already made my files. However it has been impossible to download them to the chip. I am using WebPACK 6.2i + SP1 software available from Xilinx's website. In particular I make use of the impact programmer...
Hi,
Yes it can. I have programmmed some before two three days. Have in mind that ICPROG 1.05 has a bug and doesnt write correclty the fuses to 18F452. A patch is out there to rectify this (only for 18F452).
I attach this also here (To work you need to rename your ICPROG executable as "icprog...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
