Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey guys!
Was in need of a BAT85 schottky diode and the local store gave me this. But there are no images/datasheets that justify that this is a BAT85. Is the correct component?
Hello!
1. Does anyone know the average range that could be covered with the modules nrf24l01 and esp8266 respectively?
Posts across the internet mention that the esp8266 is interesting but sufficient details about the range is not given.
Other stuff that I came to know about:
PROS (esp8266)...
Well, the distance I mentioned is for two nodes with no intermediate devices. And no possibility for them to be in the same line of sight. Any options?
I know C++ and Python. Can you describe the setup that you used?
Hello! Pretty basic question. Was wondering how microcontrollers were programmed if not through ISP. What actually happens when the microcontroller is taken out from the circuit and programmed by putting it in a socket? Can you point out the details like the protocol used in that method of...
Thanks! But I'm in need of transmitting data over a range of 2-3 km. If cheap options arent available, considering to go in for a Zigbee setup.
Right now, my question is on which software to use to process data obtained at the PC side and display it on the screen.
I'm looking for a wireless solution. I will be getting real time values from analog sensors placed remotely along with with the wireless transmitter and would then get it displayed on the computer.
Matlab is pretty good but I'm looking for simpler ones as I don't need much of the processing...
I'm planning to make it wireless, which continuously relays the information to a computer. Depending on which software is suitable, I would then decide on the hardware part of the setup.
Hi! In need of a PC setup that reads data from an external microprocessor and displays that in real time. Like a low level DAQ. Which would be the most suitable software to be used on the PC side? Considering Matlab, Labview and the like. Software with GUI plugins are more convenient.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
